Toro 04707 Installation Instructions Manual page 16

Figure 27
1. Pry bar
2. Weld side of reel support
plate
4. Rest the handle of the pry bar against the roller.
5. Complete the removal of the threaded insert
while ensuring that the pry bar stays in place,
then remove the pry bar.
6. Lower the cutting unit to rest on the rollers.
g288013
3. Reel shaft
4. Threaded insert for
removal
Restraining the Reel for Installing
Threaded Inserts
1. Insert a long-handled pry bar (recommended
3/8 inch x 12 inches with screwdriver handle)
through the front of the cutting reel, closest
to the side of the cutting unit that you will be
torquing (Figure
2. Place the pry bar against the weld side of the
reel support plate
Note:
Insert the pry bar between the top of the
reel shaft and the backs of the reel blades so
that the reel does not move.
Important:
Do not contact the cutting edge
of any blades with the pry bar; this may
damage the cutting edge or cause a high
blade.
Important:
The insert on the left side of
the cutting unit has left-hand threads. The
insert on the right side of the cutting unit has
right-hand threads.
1. Pry bar
2. Weld side of the support
plate
3. Rest the handle of the pry bar against the roller.
4. Per the insert's installation instructions and
torque requirements, complete the installation of
the threaded insert while ensuring that the pry
bar stays in place, then remove the pry bar.
16
28).
(Figure 28).
Figure 28
3. Reel shaft
4. Threaded insert for
installation
g288012