8
Installing the Groomer
Parts needed for this procedure:
4
Bolt (1/4 x 1-1/2 inches)
4
Locknut
4
Shaft clamp
Grooming reel (order separately; contact your
1
authorized Toro distributor)
Procedure
1.
Obtain a grooming reel appropriate for your
needs and cutting unit; contact your authorized
Toro distributor.
2.
Line up the grooming reel with the groomer drive
box and idler assembly
Figure 17
1. Drive-stub shaft
2. Locknut (4)
3. Groomer assembly
3.
Secure the groomer to the machine as shown in
Figure 17
and snug the bolts.
4.
To prevent binding, set the height of cut and
height of groom, then loosen the bolts.
Note:
To set the height of cut, refer to your
cutting unit Operator's Manual; refer to
(Figure
17).
g283516
4. Shaft clamp (4)
5. Bolt (4)
Adjusting
the Groomer Height (page 11)
height of groom.
5.
Torque the bolts to 5 to 7 N∙m (46 to 60 in-lb).
6.
Check and adjust the height of cut and height
of groom as necessary.
9
for adjusting the