Table of Contents
Advertisement
5
Installing the Groomer
Drive Cap
Parts needed for this procedure:
1
Cap
Procedure
Perform this procedure only for Universal
Groomer assemblies with no Rear Roller Brush
Kit installed:
1.
Apply medium-strength, cylindrical-bonding
retaining compound (such as Green Loctite
609®) around the snap ring groove and the
outer diameter surface
2.
Install the cap as shown in
1. Cap
(Figure
9).
Figure
9.
Figure 9
2. Apply medium-strength
bonding compound
6
Installing the Idler
Assembly
Parts needed for this procedure:
1
Stub-shaft assembly
2
Bearing shield
1
Idler assembly
1
Adjuster pin
1
Cotter pin
1
Flange nut
Procedure
1.
Assemble the loose parts to the idler assembly
as shown in
Important:
the fabric side toward the bearings.
g242099
1. Stub-shaft assembly
2. Bearing shield
3. Idler assembly
4. Cotter pin
2.
Position the idler assembly on the opposite side
of the reel from the groomer drive box.
3.
Use the previously removed hardware to install
the reel-drive assembly; refer to
Reel-Drive Assembly (page
6
Figure
10.
Install the bearing shields with
Figure 10
5. Adjuster pin
6. Flange nut
7. Bearing shield
3 Removing the
4).
g281674
Advertisement
Table of Contents
