Removing The Groomer Drive Box - Toro 04707 Installation Instructions Manual

Figure 23
1. Remove the drain plug
from the drain port.
2. Remove the fill plug from
the fill port.
7. Install the drain plug
8. Use a syringe (Part No. 137-0872) to fill the
drive box with 50 cc of 80-90W oil
Figure 24
1. Syringe with 50 cc of
80-90W oil
9. Install the fill plug and tighten the air-vent plug.
10. Torque all plugs to 3 to 5 N∙m (27 to 44 in-lb).
3. Loosen the air vent plug.
(Figure 22).
(Figure 24).
2. Fill port
Removing the Groomer
Drive Box
Note:
Retain all removed parts for later installation
unless otherwise stated.
Important:
If you have any issues removing the
groomer drive box, refer to your traction unit
Service Manual or contact your authorized Toro
distributor.
1. Remove the cap from the groomer.
2. Remove the clamp bolts connecting the groomer
to the drive box; refer to
the Groomer (page
3. Remove the adjuster pin and cotter pin
connecting the groomer drive box to the adjuster
arms (Figure
g283315
1. Adjuster pin
2. Cotter pin
4. Restrain the reel for removal; refer to
the Reel for Removing Threaded Inserts (page
15).
5. Install the reinforcement screw (Part No.
1-803022—sold separately) to the internal
g283314
threads of the groomer drive hex head and
torque to 13.5 N⋅m (120 in-lbs) as shown in
Figure 25.
6. Remove the groomer drive box from the cutting
reel by turning the groomer drive hex-head
(Figure 25).
Important:
installed on the right side of a cutting
unit, turn the groomer drive hex-head
counter-clockwise (right-hand thread) to
remove the drive-box shaft from cutting unit.
14
Figure 17 in
9).
25).
Figure 25
3. Groomer drive hex-head
4. Reinforcement screw
If the groomer drive box is
8 Installing
g283882
Restraining