Table of Contents
Advertisement
Figure 6
1. Wrench flats (drive-box
shaft)
2.
Assemble the shim washer over the threads of
the reel adapter
(Figure
Figure 7
1. Apply thread-locking
compound here.
2. Reel adapter into reel
shaft
3. Hex head
3.
Apply medium-strength, thread-locking
compound (such as Blue Loctite® 243) to the
internal threads of the reel shaft threads.
Important:
Clean the threads in the end of
the reel shaft of any debris or grease before
installing the splined insert.
4.
Attach the groomer drive box to the reel shaft
(Figure
7).
5.
Restrain the cutting reel to install the insert; refer
to
Restraining the Reel for Installing Threaded
Inserts (page
16).
g032791
2. Hex socket (reel adapter)
7).
g281671
4. Shim washer
5. Cutting unit
6.
While the reel is restrained, torque the hex-head
of the drive-box shaft to 135 to 150 N∙m (100 to
110 ft-lb); refer to
Important:
You must torque the hex head
of the drive-box shaft to 135 to 150 N∙m (100
to 110 ft-lb).
Important:
You must use a 6-point socket
with heavy wall.
Do not use an impact wrench for this step.
Important:
Allow the thread-locking
compound to cure for 15 minutes before
continuing the procedure.
Note:
Do not damage the seal under the outer
cover.
7.
If you are installing the groomer at the left side
of the machine, perform the following steps
(Figure
8):
A.
Remove the O-ring from the clutch knob.
B.
Remove the shear pin that secures the
clutch knob to the actuator shaft.
C.
Remove the clutch-knob assembly and flip
it over.
D.
Assemble the clutch knob to the actuator
shaft with the shear pin.
E.
Install the O-ring into the groove in the
clutch knob.
Left-side install shown
1. Shear pin
2. Clutch-knob assembly
5
Figure
7.
Figure 8
3. O-ring
g246113
Advertisement
Table of Contents
