6.
Remove the cap and to expose the bearing nut
(Figure
3).
7.
Remove the bearing nut from the reel shaft
(Figure
3).
Important:
Clean the threads in the end of
the reel shaft of any debris or grease before
installing the splined insert and groomer box
from this kit.
3
Removing the Reel-Drive
Assembly
No Parts Required
Procedure
1.
Remove the hardware that secures the reel-drive
assembly to the side plate
1. Socket-head screw
2. Spacer
3. Washer
2.
Remove the reel-drive assembly, flat washers,
spring washers, spacers, and O-rings from the
side plate
(Figure
(Figure
4).
Figure 4
4. Spring washer
5. O-ring
6. Nut
4).
4
Installing the Groomer
Drive Box
Parts needed for this procedure:
1
Reel adapter
1
Shim washer
1
Groomer drive box
Procedure
1.
Apply medium-strength, thread-locking
compound (such as Blue Loctite® 243) to the
internal threads of the drive-box shaft and torque
the reel adapter and groomer drive-box shaft to
150 to 163 N∙m (110 to 120 ft-lb).
1. Groomer drive-box shaft
Important:
g287976
compound to cure for 15 minutes before
continuing the procedure.
Note:
When torquing the reel adapter and
drive-box shaft, restrain the drive-box shaft with
a wrench on the wrench flats at the inboard side
of the groomer drive box
4
Figure 5
2. Reel adapter
Allow the thread-locking
(Figure
6).
g283538