Testing Signal And Battery Strength - Trane WZS Installation & Operation Manual

Testing Signal and Battery Strength

BAS-SVX04A-EN • Wireless Zone Sensor
Setting the Address, Mounting, Wiring, and Associating the
Receiver and Sensor
The following recommended test indicates signal and battery strength. It verifies
that the association process was successful and that the batteries have adequate
charge. (For more information on LEDs, see
Troubleshooting" on page
1. Firmly press and release the Test button (S5) on the bottom of the sensor
(Figure 14).
2. View LED1, LED2, and LED3 to determine the strength of the signal. View
LED5 to determine the strength of the battery.
Note: The LEDs will turn Off after 5 seconds to conserve battery strength.
3. Record the results in your commissioning statement.
Figure 14. Testing signal and battery strength
LED1
LED2
LED3
LED5
S5
(Test
button)
"Operation, Maintenance, and
31.)
Push S5 firmly, then release
Signal strength
27