Applying Power To The Receiver; Receiver Indicates Readiness To Associate - Trane WZS Installation & Operation Manual

Applying Power to the Receiver

Receiver Indicates Readiness to Associate

BAS-SVX04A-EN • Wireless Zone Sensor
Setting the Address, Mounting, Wiring, and Associating the
Receiver and Sensor
1. Restore power to the UCM. Observe LED5 on the receiver
light and stay constantly On when 24 V power is normal.
Figure 11. LED5 stays On after applying power to the receiver
After initial power up, the receiver conducts a channel scan for 10 seconds.
During this time, the receiver selects from 16 available channels the clearest
channel on which to operate. LED1, LED2, and LED3 flash rapidly in succession
(round-robin style) while the channel scan is in progress.
Note: Do not attempt association until the channel scan is finished.
After the channel scan is finished, LED3 will begin blinking (one-blink pattern) to
show that the receiver is ready to be associated with a sensor. LED3 will stop
blinking when association has been established
Figure 12. LED3 blinks when the receiver is ready to be associated with a sensor
(Figure
LED5 stays constantly On
(Figure 12).
LED3
LED3 will begin
to blink after
10 seconds
11). It will
25