Delta Electronics Elevator Drive VFD-VL User Manual page 98

Elevator drive
Table of Contents

Advertisement

2: Operation speed attained
3: Desired frequency attained 1 (Pr.02-25)
4: Desired frequency attained 2 (Pr.02-27)
5: Zero speed (frequency command)
6: Zero speed with stop (frequency command)
7: Over torque (OT1) (Pr.06-05~06-07)
8: Over torque (OT2) (Pr.06-08~06-10)
9: Drive ready
10: User-defined Low-voltage Detection (LV)
11: Malfunction indication
12: Mechanical brake release (Pr.02-29, Pr.02-30)
13: Overheat (Pr.06-14)
14: Brake chopper signal
15: Motor-controlled magnetic contactor output
16: Slip error (oSL)
17: Malfunction indication 1
18: Reserved
19: Brake chopper output error
20: Warning output
21: Over voltage warning
22: Over-current stall prevention warning
23: Over-voltage stall prevention warning
24: Operation mode indication (Pr.00-15≠0)
25: Forward command
26: Reverse command
27: Output when current >= Pr.02-33
28: Output when current < Pr.02-33
29: Output when frequency >= Pr.02-34
30: Output when frequency < Pr.02-34
31-32: Reserved
33: Zero speed (actual output frequency)
34: Zero speed with Stop (actual output frequency)
35: Fault output option 1 (Pr.06-22)
36: Fault output option 2 (Pr.06-23)
37: Fault output option 3 (Pr.06-24)
38: Fault output option 4 (Pr.06-25)
39: Reserved
40: Speed attained (including zero speed)
41: Reserved
Settings
Functions
0
No Function
1
AC Drive Operational
2
Operation speed attained
Revision Nov. 2008, VLE1, SW V1.03
Settings
Active when there is an output from the drive or RUN
command is ON.
Active when the AC motor drive reaches the output frequency
setting.
Chapter 4 Parameters|
Control Mode
VF
VFPG
SVC
Descriptions
FOCPG
TQCPG
FOCPM
4-43

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents