Delta Electronics Elevator Drive VFD-VL User Manual page 133

Chapter 4 Parameters|
This parameter is torque command source and the torque command is in Pr.07-12.
07-14 Maximum Torque Command
Control
VF VFPG
mode
Settings
This parameter is for the max. torque command (motor rated torque is 100%).
07-15 Filter Time of Torque Command
Control
TQCPG
mode
Settings
When the setting is too long, the control will be stable but the control response will be delay.
When the setting is too short, the response will be quickly but the control maybe unstable.
User can adjust the setting by the control and response situation.
07-16 Speed Limit Selection
Control
TQCPG
mode
Settings
torque
07-17
07-18
Pr.07-16=0
Runnin g/opposite run ning
direction are
limited by Pr.07-17
and Pr.07-18.
07-17 Torque Mode+Speed Limit
07-18 Torque Mode-Speed Limit
Control
TQCPG
mode
Settings
These parameters are used in the torque mode to limit the running direction and opposite
direction. (Pr.01-00 max. output frequency=100%)
4-78
SVC FOCPG TQCPG FOCPM
0 to 500%
0.000 to 1.000 sec
0 By Pr.07-17 and Pr.07-18
1 Frequency command source (Pr.00-14)
torque
frequency
07-18
07-16=1
When it is forwa rd running,
running direction is limited
by Pr.00-14
opposite running direction
is limited by Pr.07-18.
0 to 120%
frequency
00-14
Factory Setting: 100
Factory Setting: 0.000
Factory Setting: 0
torque
frequency
07-17
00-14
07-16=1
When it is reverse running,
running direction is limited
by Pr.07-17
opposite running direction
is limited by Pr.00-14.
Factory Setting: 10
Revision Nov. 2008, VLE1, SW V1.03
Unit: 1
Unit: 0.001
Unit: 1
Unit: 1