Delta Electronics Elevator Drive VFD-VL User Manual page 114

05-06 Rs of Motor
Control
SVC FOCPG TQCPG
mode
Rr of Motor
05-07
Control
SVC FOCPG TQCPG
mode
Settings
05-08 Lm of Motor
Control
SVC FOCPG TQCPG
mode
05-09 Lx of Motor
Control
SVC FOCPG TQCPG
mode
Settings
05-10 Torque Compensation Time Constant
Control
SVC
mode
Settings
05-11 Slip Compensation Time Constant
Control
SVC
mode
Settings
Setting Pr.05-10 and Pr.05-11 change the response time for the compensation.
When Pr.05-10 and Pr.05-11 are set to 10 seconds, its response time for the compensation
will be the longest. But if the settings are too short, unstable system may occur.
05-12 Torque Compensation Gain
Control
VF VFPG
mode
Settings
This parameter may be set so that the AC motor drive will increase its voltage output to obtain
a higher torque.
05-13 Slip Compensation Gain
Control
SVC VFPG
mode
Settings
Revision Nov. 2008, VLE1, SW V1.03
0.000~65.535Ω
0.0~6553.5mH
0.001 to 10.000 sec
0.001 to 10.000 sec
0 to10
SVC
0.00 to10.00
Chapter 4 Parameters|
Unit: 0.001
Factory setting: 0.000
Unit: 0.001
Factory setting: 0.000
Factory setting: 0.0
Factory setting: 0.0
Unit: 0.001
Factory setting: 0.020
Unit: 0.001
Factory setting: 0.100
Factory setting: 0
Factory setting: 0.00
Unit: 0.1
Unit: 0.1
Unit: 1
Unit: 0.01
4-59