Delta Electronics Elevator Drive VFD-VL User Manual page 101

Chapter 4 Parameters|
Settings Functions
Speed Attained
40
(including zero speed)
41 Reserved
02-23 Multi-output Direction
Control
VF VFPG
mode
Settings
This parameter is bit setting. If the bit is 1, the multi-function output terminal will be act with
opposite direction. For example, if Pr.02-11 is set to 1 and forward bit is 0, Relay 1 will be ON
when the drive is running and OFF when the drive is stop.
The multi-function output terminals MO3~MO10 need to use with EMVL-IODA01.
Bit 11 Bit 10 Bit 9 Bit 8 Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
MO10 MO9 MO8 MO7 MO6 MO5 MO4 MO3 MO2 MO1 MRA
02-24 Serial Start Signal Selection
Control
VF VFPG
mode
Settings
This parameter is used to select serial start method of electromagnetic valve.
When setting to 0
FWD
forward
running
Multifunction
output MO=15
MC1
Electr omagnetic valve
4-46
Active when the output frequency reaches frequency setting.
SVC FOCPG TQCPG FOCPM
0 ~ 65535
SVC FOCPG FOCPM
0 by FWD/REV
1
by Enable
Enable
REV
MC1
rev er se Multifunction
input MI=40
running
Descriptions
When setting to 1
FWD REV
rev er se
forward
running
running
Multifunction
output MO=15
MC1
Electr omagnetic valve
Revision Nov. 2008, VLE1, SW V1.03
Unit:1
Factory setting: 0
RA
Factory setting: 0
Enable
MC1
Multifunction
input MI=40