Table of Contents
Advertisement
Installation (cont'd)
Glass Adjustment
Follow these steps accordingly to properly and safely
adjust the positioning of the front glass.
Before adjusting glass
Set, Level, and Bolt together all cases
STOP
Double check leveling for all cases
Do not move lineup during adjustment
UP & DOWN
IN & OUT
1. GENTLY LOOSEN SCREW SHOWN
2. PHYSICALLY MOVE HINGE/GLASS UP OR DOWN
3. TIGHTEN SCREW AFTER FINAL POSITIONING
NOTE:
PERFORM STEP 1 ON ALL HINGES BEFORE LEVELING
CANOPY
TURNING THE SCREWDRIVER
CLOCKWISE WILL CAUSE THE
HINGE TO ADJUST INWARD
TURNING THE SCREWDRIVER
COUNTER- CLOCKWISE WILL CAUSE
THE HINGE TO ADJUST OUTWARD
HINGE
ASSEMBLY
(GLASS NOT
SHOW
UPPER
HINGE
COVER
SCREW
LEFT & RIGHT
TURNING THE SCREWDRIVER
COUNTER- CLOCKWISE WILL CAUSE
THE HINGE TO ADJUST RIGHT
Glass must be parallel to front ledge when viewed from
front. Glass height should be centered on "V" Glass Seal
as demonstrated below.
14
HINGE
ASSEMBLY
(GLASS NOT
SHOW
UPPER & LOWER HINGE
ACCESS
SCREW
TURNING THE SCREWDRIVER
CLOCKWISE WILL CAUSE THE
HINGE TO ADJUST LEFT
ALIGN GLASS
WITH "V" SEAL
LOWER
HINGE
COVER
SCREW
Advertisement
Table of Contents
