Table of Contents
Advertisement
Port Aggregation
In order to use multiple transmission paths between network devices so there can be an
increase in transmission speeds then the Port Aggregation feature can be used. Select the
[Layer2]
[Port Aggregation
Aggregation.
Port Aggregate Configuration Parameter Description
Parameter
Load Balance
System Priority
System ID
[Configuration] submenu to begin configuring Port
Description
When transferring a packet to the opposite party through a
trunk port then the packet is transferred to a port among
members included in the trunk group. Select an algorithm to
select a port for transfer at this time.
The default is Direct-MAP based DMAC & SMAC & SPORT-ID.
- CRC based DMAC & SMAC
- Direct-MAP based DMAC & SMAC
- CRC based DMAC & SMAC & SPORT-ID
- Direct-MAP based DMAC & SMAC & SPORT-ID
A protocol setup value used in a LACP. The default is 32768.
An identification value used in LACP. This value is the same as
the value of the MAC address in the system.
37
Advertisement
Table of Contents
