Table of Contents
Advertisement
GPLIMT/GPLIM Installation
1.
Insert the GPLIMT/GPLIM into an open slot in the OfficeServ 7400 cabinet
slots 0 or 3 which are reserved for the MP40 and LP40
2.
Connect a PC to any port (P1 –P12) of the GPLIMT/GPLIM module with either a
straight or cross over cable.. Installers will need to configure the TCP/IP settings of the
PC to be on the same subnet as the default Management IP address of the
GPLIMT/GPLIM shown in step 3.
3.
Using Internet Explorer 6.0 or higher navigate to the default Management IP address of
the GPLIMT/GPLIM board (10.0.4.1/24 (https://10.0.4.1).
Caution when using a Web Browser
The version of Internet Explorer should be 6.0 or higher when logging in and performing
maintenance on the GPLIMT/GPLIM. Other web browsers are not supported.
14
(excluding
cards).
Advertisement
Table of Contents
