Samsung OfficeServ 7400 GPLIMT User Manual page 34

RSTP Protocol Status/Bridge/Port Parameter Description
Parameter
Protocol Status Used to display the current status of the RSTP protocol.
Bridge Used to configure the Bridge parameters of the switch that
Parameter RSTP uses.
- Bridge Priority: Used to set the priority of Bridges.
- Hello Time: Used to set the transmission cycle of BPDU.
- Max Age Time: Used to set the Message Age time.
- Forward Time: Used to set the time that the state of each port
is changed (Discarding-Learning-Forwarding).
Port Parameter - Priority: Standard to select the port to be blocked when the
switch loop is established.
- Force Version: Communication is progressed via the switch
connected to the corresponding port and the BPDU that a
user specifies. For '0', STP BPDU is transmitted. For '1',
RSTP BPDU is transmitted.
- Path Cost: Used to set and display the path cost according to
the bandwidth when the connection with the opponent is
established.
- Port Fast: If the port is enabled for Port Fast then the port
becomes an Edge port and quickly goes into a forwarding
state. If this function is activated then the MAC address
learned in the corresponding port is not canceled even when
all topologies of Bridges are changed.(If STP is used then the
Port Fast function should be disabled.)
- Link Type: Used to set and display the type of the link
connected to the opponent. The link is connected as point-to-
point in RSTP.
Description
34