Crankcase Disassembly / Inspection - Polaris GENERAL 2016 Service Manual

ENGINE / COOLING SYSTEM
3. Remove the one-way clutch and inspect both sides
q
of drive rollers . Inspect the roller contact surface
w
inside the hub for wear, damage or uneven
surface.
4. Inspect drive surface of starter gear
r
for wear, damage or uneven surface. If any starter
one-way clutch component is worn or damaged,
replace the clutch and starter gear as an assembly.

CRANKCASE DISASSEMBLY / INSPECTION

1. Remove the four screws retaining the oil cooler
the crankcase.
3.48
2. Remove the crankcase drain plug
remaining in the engine. Reinstall the plug.
3. Remove the oil filter.
4. Install the Cylinder Holding & Camshaft Timing Plate
e
and bushing
(PU-50563)
tool retains the cylinder and pistons when the engine
is rotated.
5. Rotate engine to access the crankcase sump cover.
6. Remove the thirteen M6
retaining the sump cover
q
to
9929375 R02 - 2016-2019 GENERAL / GENERAL 4 Service Manual
w
e
onto the cylinder. The cylinder holding
t
and three M8 bolts
r
to the crankcase.
© Copyright Polaris Industries Inc.
. Drain any oil
y