Etc Learn Procedure - Polaris GENERAL 2016 Service Manual

Table of Contents

5. Remove the ETC housing and gasket

6. Reverse these steps for installation. Torque the ETC

housing retaining bolts and intake boot clamp to

specification.

ETC Housing Retaining Bolts:

5 lb-ft (7 Nm)

Intake Boot Clamp:

49 lb-in (5.5 Nm)

ETC LEARN PROCEDURE

This procedure MUST be performed on the vehicle

whenever the ECU is replaced or reflashed or the

throttle body is replaced.

1. After the reflash / ECU replacement / throttle body

change, leave the key on (engine not running) for 60

seconds. Do NOT crank the engine during this time.

2. Turn the key off and wait 3 minutes. During this time,

the ECU will write values into memory and then

completely shut down.

3. Turn key back on and start the vehicle. The vehicle

should operate normally.

4. If the procedure was interrupted at any time, start

back at step 1.

9929375 R02 - 2016-2019 GENERAL / GENERAL 4 Service Manual

Table of Contents