Assembly Continued - Polaris GENERAL 2016 Service Manual

8. Place shock shaft in clamp blocks and insert needle
into shock shaft.
9. Thread in the damping jet and torque to specification.
TORQUE
Damping Jet: 40 lb-in (4.5 Nm)
10. Reverse shock shaft in clamp blocks and apply a thin
layer of Slick Honey to metering rod.
9929375 R02 - 2016-2019 GENERAL / GENERAL 4 Service Manual
© Copyright Polaris Industries Inc.
STEERING / SUSPENSION

ASSEMBLY CONTINUED

1. Apply specified Loctite® two threads down and two
threads wide completely around shock shaft threads.
2. Place shaft back in clamp blocks, apply Loctite®
primer to eyelet, and Torque eyelet to shock shaft to
specification.
TORQUE
Eyelet: 30 lb-ft (41 Nm)
3. Reverse shock shaft in clamp blocks and install air
side shaft spacers (if equipped) and jounce bumper.
8
8.35