Viessmann Vitodens 333 Service Instructions Manual page 49

Code 2
(cont.)
Coding in the delivered condition
58:0 Without auxiliary func-
tion for DHW heating
59:0 Cylinder heating:
Starting point 2.5 K
Stopping point +2.5 K
60:20 During DHW heating,
the boiler water tem-
perature is max. 20 K
higher than the set
DHW temperature
62:2 Circulation pump with
2 min run on time after
cylinder heating
63:0 No default interval for
auxiliary function for
DHW heating (only for
constant temperature
control units)
65:... Information regarding
the type of diverter
valve; do not adjust.
6C:100 Set speed; internal pri-
mary pump for DHW
heating 100%.
Never adjust.
6F:... Maximum output for
DHW heating in %; de-
faulted by the boiler
coding card
Possible change
58:10 Input of a second set
to DHW value, adjustable
58:60 from 10 to 60 °C (observe
the coding addresses
"56" and "63")
59:1 Starting point adjustable
to from 1 10 K below the set
59:10 value
60:5 The difference between
to the boiler water tempera-
60:25 ture and the set DHW
temperature is adjustable
from 5 to 25 K
62:0 Circulation pump without
run on
62:1 Run on time adjustable
to from 1 to 15 min
62:15
63:1 Auxiliary function for
DHW heating, 1 x daily
63:2 Every 2 days to every 14
to days
63:14
63:15 2 x daily
65:0 Without diverter valve
65:1 Diverter valve by
Viessmann
65:2 Diverter valve by Wilo
65:3 Diverter valve by Grund-
fos
6F:0 Max. output during DHW
to heating adjustable from
6F:100 min. output to 100%
Coding
49