Isdn Feature Programming - NEC Neax 2000 IVS2 Manual

CHAPTER 3 SYSTEM DATA PROGRAMMING

ISDN Feature Programming

ISDN FEATURE PROGRAMMING
• Calling Party Recognition Service (Direct-In Termination (DIT))
Refer to "Direct Inward Termination (DIT)" in the Feature Programming Manual.
• DID Addressing
®
• MEGACOM Access
®
• MEGACOM 800 Service
Refer to "DID Addressing" for programming instructions. (See
• SID to Network-Present
• CPN to Network-Present
• SID to Terminating User-Display
No programming is required.
• CPN to Terminating User-Display
No programming is required.
• Subaddress-Present (See
• Trunk Provisioning Service Selection (See
• ISDN PRI Call By Call Service Selection
• Advice of Charge (AOC)
• Centrex SHF over ISDN
Page 82
(See Page 83.)
[North America Only]
[North America Only]
[Australia/Other Countries]
[North America]
[Australia/Other Countries]
[North America]
Page 89.)
[Australia/France Only]
(See
[N.Z. Only]
(See Page 85.)
(See Page
(See Page 86.)
Page 90.)
[North America Only]
(See Page 97.)
Page 98.)
Page 83.)
86.)
(See Page 91.)
2
NEAX2000 IVS ISDN System Manual
ND-70919 (E), Issue 1.0