NEC Neax 2000 IVS2 Manual page 87

CHAPTER 3 SYSTEM DATA PROGRAMMING
ISDN-BRI Programming
A
Assign trunk route to each ISDN trunk
CM30
used for Voice channel (B channel).
NOTE: BRT route must be separated
from analog trunk routes.
Assign the trunk route data to each ISDN
incoming trunk used for Voice channel
only.
NOTE: If CM35 YYY=143 is set to "1" for
Event Based CCIS, this command
must be set to "18" (ISDN Indial).
Assign ISDN Local Office Code Table
number to each ISDN trunk.
Assign trunk route data to the route
CM35
number assigned by CM30 YY=00.
B
Page 76
DESCRIPTION DATA
YY=00
•
(1) 000-255: Trunk No. assigned by CM07
YY=01
(2) 00-63: Trunk Route
YY=02 Day Mode
•
• YY=03 Night Mode
• YY=40 Mode A
• YY=41 Mode B
(1) 000-255: Trunk No. assigned by CM07
YY=01
(2) 04: Direct-In Termination
09: Automated Attendant
14: Termination to Attendant Console
16: Remote Access to System (DISA)
18: ISDN Indial
• YY=34
(1) 000-255: Trunk No. assigned by CM07
YY=02
(2) 00-14: Local Office Table No.
15 : Not assigned
YY=00 Kind of Trunk Route
•
(1) 00-63: B channel Trunk Route No.
(2) 00: ISDN Trunk
(1) 00-63: D channel Trunk Route No.
(2) 15 : Not used
YY=02 Call Direction
•
(1) 00-63: B channel Trunk Route No.
(2) 3 : Bothway Trunk
• YY=04 Answer Signal from distant
office
(1) 00-63: B channel Trunk Route No.
(2) 2: Answer signal arrives (ISDN Trunk)
(1) 00-63: D channel Trunk Route No.
(2) 7 : Not used
NEAX2000 IVS
NOTE 1
2
ISDN System Manual
ND-70919 (E), Issue 1.0