NEC Neax 2000 IVS2 Manual page 89

CHAPTER 3 SYSTEM DATA PROGRAMMING
ISDN-BRI Programming
C
CM35
NOTE 1: This data should be assigned to
NOTE 2: This data should be assigned to
Specify the method of Layer 1 activation.
Assign ISDN Local Office Code.
CM50
Assign Service Profile ID (SPID) to each B
CMAC
channel number.
[North America Only]
D
Page 78
DESCRIPTION
the B channel trunk route. For
D channel trunk route, no data
setting is required.
both B channel trunk route and
D channel trunk route.
DATA
YY=19
•
(1) 00-63: B channel Trunk Route No.
(2) 0-3 : Programmable PAD
(See CM42)
4-7 : Fixed PAD
NOTE: For details of PAD data, refer to
Command Manual.
YY=28 Outgoing Trunk Queuing
•
(1) 00-63: B channel Trunk Route No.
NOTE 1
(2) 0: Restricted
YY=39 Trunk release by detection of
•
reversal of tip and ring
(1) 00-63: B channel Trunk Route No.
NOTE 1
(2) 1 : To release
YY=90 Assignment of BRT route for
•
ISDN
(1) 00-63: B channel/D channel Trunk
Route No.
(2)
2: ISDN-Basic Rate Interface
YYY=144
•
(1) 00-63: B channel/D channel Trunk
Route No.
(2) 0 : Activated by call event
1 : Always activated
• YY=05
(1) 00-14: Local Office Table No. assigned
by CM30 YY=34
(2) X....X
(Max. 12 digits)
• YY=30
(1) XX Z
XX: 04-15: AP No. assigned by CM05
Z : 0-3: B ch No.
(2) XXXX ZZZZ
XXXX: ISDN Subscriber No.
ZZZZ : SPID
NEAX2000 IVS
NOTE 1
NOTE 2
2
ISDN System Manual
ND-70919 (E), Issue 1.0