CHAPTER 3 SYSTEM DATA PROGRAMMING
Event Based CCIS Programming
• To connect the ISDN line for the voice channel after the called party answers, do the
following programming.
By the following programming, the ISDN line for the voice channel is not connected, until the
called party answers, or when the called party does not answers the call.
NOTE: This feature is available only for the connection between the NEAX2000 IVS
M100MX's. The same programming must be set on the opposite office.
START
Specify the ISDN answer signal sending
CM35
timing as "when the called party answers".
Specify the kind of the Information Transfer
Capability of voice channel trunk route as
"Speech".
END
Page 130
DESCRIPTION
DATA
YYY=153
•
(1)
00-63: Trunk Route No. of Mate-Side
Trunk for voice channels
(2)
0: Send when the called party answers
•
YYY=154
(1)
00-63: Trunk Route No. of Mate-Side
Trunk for voice channels
(2)
6: Speech
NEAX2000 IVS
2
/7400ICS
2
ISDN System Manual
ND-70919 (E), Issue 1.0