Mate-Side Trunk Programming - NEC Neax 2000 IVS2 Manual

CHAPTER 3 SYSTEM DATA PROGRAMMING
Event Based CCIS Programming

Mate-Side Trunk Programming

START
Assign a trunk number to each channel on
CM07
the Mate-Side trunk.
NOTE: The Virtual channel number on
the Mate-Side Trunk must be an
odd number (01, 03, 05, ... 31).
Assign a trunk route number to each trunk.
CM30
Assign a trunk number, of the opposite
office, sent to the network on Event Based
CCIS connection. The trunk number is
sent by the subaddress to activate the
relation between the trunks used for Event
Based CCIS.
NOTE 1: CM30 YY=19 is not required
NOTE 2: CM30 YY=19 must be an
Assign trunk route data to the voice
CM35
channels and common signaling channel
of the Event Based CCIS route, as Tie
Lines.
Assign the abbreviated codes for
terminating number of the opposite office.
The terminating number and its memory
allocation should be assigned by CM71,
CM72.
A
Page 124
DESCRIPTION
when the trunk number is sent
by ISDN Indial dialed-in digits.
(CM35 YYY=143>1)
unique combination between
the offices.
YY=05
•
(1) 3201-3231: Virtual channel No. 01-31
(2) D000-D255: Trunk No.
INITIAL
YY=00
•
(1) 000-255: Trunk No.
(2) 00-63: Trunk Route No.
• YY=19
(1) 000-255: Trunk No.
(2) X-XXXX: Trunk No. of the opposite of-
• YY=00
(1) 00-63: Trunk Route No.
(2) 04: Tie Line
YY=40
•
(1) 00-63: Trunk Route No.
(2) 00-31: Abbreviated Codes
DATA
(Odd No.) of the Mate-Side
Trunk
fice
2
NEAX2000 IVS ISDN System Manual
ND-70919 (E), Issue 1.0