NEC Neax 2000 IVS2 Manual page 80

D
CM35 NOTE 1: This data should be assigned to
NOTE 2: This data should be assigned to
E
2
NEAX2000 IVS ISDN System Manual
ND-70919 (E), Issue 1.0
DESCRIPTION
the B channel trunk route. For
D channel trunk route, no data
setting is required.
both B channel trunk route and
D channel trunk route.
CHAPTER 3 SYSTEM DATA PROGRAMMING
• YY=16
Hooking Signal Sending to outside
(1) 00-63: B channel Trunk Route No.
(2) 0: Not sending
• YY=18 Digit conversion on DID call
(1) 00-63: B channel Trunk Route No.
(2) 0 : Provided
1 : Not provided
YY=19
•
(1) 00-63: B channel Trunk Route No.
(2) 0-3 : Programmable PAD
(See CM42)
4-7 : Fixed PAD
NOTE: For details of PAD data, refer to
Command Manual.
YY=28 Outgoing Trunk Queuing
•
(1) 00-63: B channel Trunk Route No.
(2) 0: Restricted
• YY=39 Trunk release by detection of
reversal of tip and ring
(1) 00-63: B channel Trunk Route No.
(2) 1 : To release
YY=89 CRC error check
•
(1) 00-63: B channel Trunk Route No.
NOTE 1
(2) 0: Provided
YY=90 Assignment of DTI route for
•
ISDN
(1) 00-63: B channel/D channel Trunk
Route No.
(2) 3: ISDN-Primary Rate Interface
ISDN-PRI Programming
DATA
NOTE 1
NOTE 1
NOTE 1
NOTE 1
NOTE 2
Page 69