Sewing In Tape - JUKI MO-655N Instruction Manual

Sewing in tape

B
A
33
Sewing in tape
Be sure to turn power switch OFF.
Switch the machine off (power switch"O")
The standard presser foot is equipped with a tape guide. When
sewing shoulders or side seams of stretchy fabrics as a knitted fab-
ric, a tape works effectively to stabilize the seam.
1. Remove the upper looper thread, and insert the 2/3 thread con-
verter into the top section (A) of the upper looper shaft and fit
wire (B) into the hole in the upper looper.
2. Raise the presser foot, place the tape in the groove on the
presser foot, and lower the presser foot.
3. Loosen the guide adjusting screw (A) to fit the tape guide (B) to
the tape width, then tighten the screw.
4. Turn the handwheel manually to make two or three stitches in
the tape.
5. Place the fabric to be sewn under the presser foot.
6. Sew, guiding the tape lightly.