Table of Contents
Advertisement
Threading: 5-thread overlock (chainstich & 3-thread overlock)
19
2. Lower looper thread (Red)
Place the spool on the spool pin right under red marking on the
retractable support rod thread guide.
(1)
Bring thread up from the rear of the retractable support rod
thread guide.
(2,3) Pass the thread through the thread guide plate. Snapping into
place.
(4)
Snap the thread in to the thread guide.
(5)
Thread the thread tension dial.
(6,7,8,9) Thread the thread guides.
(10) Raise the needles fully and press the lever of the threading
device down.
Thread upper looper eye.
(11,12) Thread the guide and then the slit on the device. Holding the
thread loosely with the left hand, turn the hand wheel until
upper and lower loopers just cross. The threading device will
automatically return to the normal position.
(13) Thread the lower looper eye and place thread under the press-
er foot.
* If rethreading the lower looper thread, cut the needle threads
at the needle. And rethread needle threads. Thread the lower
looper and then the needles.
Advertisement
Table of Contents
