Table of Contents
Advertisement
Threading: 4 thread overlock
7
6
8
9
11
10
27
28
1
2
3
4
5
8
9
10
3. Right-hand needle thread (Green)
Place the spool on the spool pin right under the green marking on
the retractable support rod thread guide.
(1)
Bring thread up from the rear of the retractable support rod
thread guide with the green marking.
(2,3) Pass the thread through the thread guide plate. Looping as
shown.
(4)
Thread the thread tension dial.
(5,6) Thread the thread guide.
(7)
Lay the thread in the under notch on the thread take-up cover.
(8)
Thread the thread guide.
(9)
Thread the thread guide on the needle clamp.
(10) Turn the handwheel toward you until the needles are fully
raised. Thread the right-hand needle.
(11) Bring the thread under the presser foot and pull about 10 cm
of the thread out behind the presser foot.
Advertisement
Table of Contents
