Table of Contents
Advertisement
Threading: 4 thread overlock
1
2
6
3
5
7
8
9
7
8
9
4
4. Left-hand thread needle (Yellow)
Place the spool on the spool pin right under the yellow marking on
retractable support rod thread guide.
(1)
Bring the thread up from the spool to the thread guide and
take it through the yellow thread guide.
(2,3) Thread the thread guide. Looping as shown.
(4)
Thread the thread tension dial.
(5)
Thread the thread guide.
(6)
Lay the thread in the center notch on the thread take-up cover.
(7,8) Thread the thread guides.
(9)
Thread the left-hand needle. Pull about 10 cm of the thread
out from the needle eye.
When threading is completed, lower the upper knife and close the
looper cover and cloth plate.
28
Advertisement
Table of Contents
