Table of Contents
Advertisement
2/3 thread converter
2-thread flatlook
2-thread wrapped overlook
B
C
D
E
Be sure to turn power switch OFF.
How to use the 2/3 thread converter
Switch the machine off (power switch"O")
* This attachment enables the machine to perform 2 thread
overedging or decorative-stitching, using 2 needles to perform
3-thread super stretch stitching.
①
Remove the upper looper thread, and insert the 2/3 thread con-
verter into the top section (A) of the upper looper shaft and fit wire
(B) into the hole in the upper looper.
Upper looper (C):
Push the wire behind looper and into the eye of the looper.
(D): If the wire is not sufficiently springy or it cannot be fitted in
A
the hole in the upper looper smoothly, adjust the curved sec-
tion of the wire.
31
30
Advertisement
Table of Contents
