Table of Contents
Advertisement
Threading: 5-thread overlock (chainstich & 3-thread overlock)
1
6
2
3
5
7
8
10
9
6
5
7
4
8
9
5. Chainstitch needle thread (purple)
Place the spool on the spool pin right under the puple marking on
retractable support rod thread guide.
(1)
Bring the thread up from the spool to the thread guide and
take it through the purple thread guide.
(2,3) Thread the thread guide.
(4)
Thread the thread tension dial.
(5)
Thread the thread guide.
(6)
Lay the thread in the up side notch on the thread take-up cov-
er.
(7,8,9) Push the chainstitch looper auto-threader up towards the
chainstitch looper and press them down together.
(10) Thread the chainstitch needle. Pull about 10 cm of the thread
out from the needle eye.
When threading is completed, lower the upper knife and close the
looper cover and cloth plate. Switch the machine on.
23
22
Advertisement
Table of Contents
