Table of Contents
Advertisement
Fault
Appliance is not heat-
ing, the colon flashes
in the display and a
appears.
The appliance door
cannot be opened
and
lights up in the
display.
The appliance door
cannot be opened
and lights up in the
display.
The time flashes in
the display.
The time does not ap-
pear in the display
when the appliance is
switched off.
lights up in the dis-
play and no settings
can be made on the
appliance.
flashes in the dis-
play and the appli-
ance does not start.
appears in the
display.
A message with ap-
pears in the display,
e.g.
-
.
34.2 Information on the display panel
Fault
No displays light up.
The displays flash.
Cause and troubleshooting
Demo mode is activated.
1.
Briefly disconnect the appliance from the power supply by switching the circuit breaker in
the fuse box off and then on again.
Deactivate demo mode within 5 minutes by changing the last basic setting (depending
2.
on the appliance type or ) to .
→ "Basic settings", Page 22
The childproof lock locks the appliance door.
Use
to deactivate childproof lock.
▶
→ "Childproof lock", Page 30
The cleaning function locks the appliance door.
Allow the appliance to cool down until
▶
→ "Pyrolysis", Page 33
There has been a power cut.
Reset the time.
▶
→ "Setting the time", Page 26
The basic setting has been changed.
Change the basic setting for the time display.
▶
→ "Basic settings", Page 22
Childproof lock is activated.
Use the
button to deactivate the childproof lock.
▶
The cooking compartment is too hot for the selected operation.
Switch off the machine and allow it to cool.
1.
Restart the operation.
2.
The maximum cooking time has been reached. To prevent an unwanted permanent opera-
tion, the appliance automatically stops heating after several hours if the settings are un-
changed.
Switch off the appliance.
▶
Implement new settings, if required.
Tip: To prevent the appliance from switching off when you do not want it to, e.g. for an
extremely long preparation time, set a cooking time.
→ "Time-setting options", Page 25
Electronics fault
Press
.
1.
If necessary, reset the time on the clock.
‒
a If the fault was a one-off, the error message disappears.
If the error message appears again, call the after-sales service. State the exact error
2.
message and the E no. for your appliance in full.
→ "Customer Service", Page 43
Cause and troubleshooting
The power supply has been disconnected.
Use other electrical appliances to check whether there has been a power failure.
▶
The appliance has not been connected as shown in the circuit diagram.
Connect the appliance in accordance with the circuit diagram.
▶
Electronics fault
If you are unable to rectify the fault, inform the technical after-sales service.
▶
The control panel is wet or an object is covering it.
Dry the control panel or remove the object.
▶
goes out in the display.
Troubleshooting en
41
Advertisement
Table of Contents
