Table of Contents
Advertisement
en Appliance door
Fit the retaining clips onto the right- and left-hand
3.
side of the pane, aligning them so that the springs
are over the screw holes. Screw the retaining clips
in place.
Insert the seal below the pane.
4.
Hold the top pane in both brackets and insert it at
5.
an angle towards the back.
Ensure that the seal does not slip backwards.
Fit the two small seals on the left and right of the
6.
pane again.
Put the cover back in place and screw it on.
7.
Attach the oven door.
8.
→ "Attaching the appliance door", Page 38
38
Note: Only use the oven once the glass panes have
been correctly fitted.
32.5 Attaching the appliance door
Reattach the oven door in the reverse sequence to re-
moval.
WARNING ‒ Risk of injury!
The oven door might accidentally fall or a hinge may
suddenly snap shut.
In this case, do not hold onto the hinge. Call cus-
▶
tomer service.
When attaching the oven door, ensure that both
1.
hinges are inserted in the opening direction.
The notch on the hinge must engage on both sides.
2.
Close both locking levers again.
3.
Close the appliance door.
4.
Advertisement
Table of Contents
