Table of Contents
Advertisement
en Checking the cookware
19 Checking the cookware
You can use this function to check the speed and qual-
ity of the cooking process depending on the cookware.
The result is a reference value and depends on the
properties of the cookware and the cooking zone being
used.
You can find more information about this function un-
der
→ "Basic settings", Page 22 and on the type, size and
positioning of the cookware under
→ "Induction cooking", Page 9.
19.1 Procedure for checking the cookware
Fill the cookware with approximately 200 ml water
1.
and place it at room temperature in the middle of
the cooking zone that most closely matches the dia-
meter of the base of the cookware.
Call up the basic settings and select .
2.
Touch the control panel. The
3.
the cooking zones.
a The function has now been activated.
a After 20 seconds, the result appears in the cooking
zone displays.
20 PowerManager function
You can use the PowerManager function to configure
the total power of the hob.
The hob settings are preconfigured at the factory. You
can use this function to configure the settings in ac-
cordance with the requirements of an electrical installa-
tion.
In order to not exceed this set value, the hob automat-
ically distributes the available power as needed
between the cooking zones that are switched on.
21 Basic operation
21.1 Switching on the appliance
Turn the function selector to any position other than
▶
the "Off" position .
a The appliance is switched on.
24
display flashes in
Note: If the diameter of the cooking zone that is used
is much smaller than the diameter of the cookware,
only the middle of the cookware can be expected to
heat up. This may result in the cooking results not be-
ing as good as expected or being less than satisfact-
ory.
19.2 Checking the result
In the following table, you can check the result for the
quality and speed of the cooking process:
Result
The cookware is not suitable for the
cooking zone and therefore does not
heat up.
The cookware is taking longer to heat
up than expected and cooking is not
progressing as well as it ought to.
The cookware is heating up correctly
and cooking is progressing well.
1
If a smaller cooking zone is available, test the cook-
ware on this cooking zone.
To activate this function, touch the settings range.
While the PowerManager function is activated, the out-
put of a cooking zone may temporarily fall below the
nominal value. In order to not exceed this set value, the
hob automatically distributes the available power as
needed between the cooking zones that are switched
on . The appliance regulates and selects the highest
power level automatically.
If the automatic power limitation is activated, the appli-
ance self-regulates but continues to display the selec-
ted power level unchanged.
For more information, go to .
21.2 Switching off the appliance
Turn the function selector to the "Off" position .
▶
a The appliance is switched off.
1
1
Advertisement
Table of Contents
