Reservoir Calibration - Smeg Classica SO6104APN Manual

Reservoir calibration

This function allows you to calibrate the
correct reading of the quantity of water
(or other liquid) inside the reservoir.
Over time, the quantities of water in the reservoir
may not be read correctly by the appliance
sensor. In this case, the functionality of the
appliance sensor can be restored to an optimal
condition.
Preliminary operations
1. Touch the OTHER FUNCTIONS
button on the "main menu" (in the main area
).
2. Touch the sub-menu
the lower area
3. Touch the RESERVOIR CALIBRATION
button (positioned in the lower area
).
Empty reservoir calibration
1. Open the appliance door.
2. Place an empty jug on the open door.
3. Touch the WAND button
display (positioned in the lower area
Pay attention to the distance to be
maintained so as not to be hit by the
wand projection.
4. Pull out the wand and dip the end into the
bottom of the empty jug.
5. Press the START
the water left in the jug.
6. Wait for the end of the drain flow.
132 - CLEANING AND MAINTENANCE
button (located in
).
on the
button to start draining
7. Make sure that no more water comes out of
the wand, then touch the STOP button
8. Then touch the EMPTY RESERVOIR
CALIBRATION button
calibration.
Full reservoir calibration
1. Fill a jug with exactly 1 litre of water.
We recommend using a digital kitchen
scale and measuring 1000 grams of
water.
2. Place the jug with 1 litre of water on the
open door.
3. Immerse the end of it into the jug until it
reaches the bottom.
).
4. Press the START
appliance reservoir with water.
5. Wait for the end of the reservoir filling.
6. Make sure that the appliance has sucked up
all the water contained in the jug, then touch
the STOP button
7. Place the loading wand back in its holder.
8. Remove the jug.
to continue
button to start filling the
.
91477A081/A
.