Reservoir Calibration - Smeg SO4604S4PNR Manual

9. Place the loading wand back in its holder.
10. Remove the jug (or container).
11. Close the door.
12. Touch the START
selected steam function.
13. Wait for the function to be executed until the
end.
14. At the end of the function, drain the reservoir
as described above.
15. Wait for the end of the drain flow.
16. Drain the water from the jug.
Take care: wait for the oven cavity to
cool down.
17. Open the door.
18. Wipe off any spillage of water in the oven
cavity with a cloth or sponge.
19. Close the door.

Reservoir calibration

This function allows you to calibrate the
correct reading of the quantity of water
(or other liquid) inside the reservoir.
Over time, the quantities of water in the reservoir
may not be read correctly by the appliance
sensor. In this case, the functionality of the
appliance sensor can be restored to an optimal
condition.
Preliminary operations
1. Touch the OTHER FUNCTIONS
button on the "main menu" (in the main area
).
2. Touch the sub-menu
the lower area
3. Touch the RESERVOIR CALIBRATION
button (positioned in the lower area
).
Empty reservoir calibration
1. Open the appliance door.
2. Place an empty jug on the open door.
91477A485/A
button to start the
button (located in
).
3. Touch the WAND button
display (positioned in the lower area
Pay attention to the distance to be
maintained so as not to be hit by the
wand projection.
4. Pull out the wand and dip the end into the
bottom of the empty jug.
5. Press the START
the water left in the jug.
6. Wait for the end of the drain flow.
7. Make sure that no more water comes out of
the wand, then touch the STOP button
8. Then touch the EMPTY RESERVOIR
CALIBRATION button
calibration.
Full reservoir calibration
1. Fill a jug with exactly 1 litre of water.
We recommend using a digital kitchen
scale and measuring 1000 grams of
water.
2. Place the jug with 1 litre of water on the
open door.
CLEANING AND MAINTENANCE - 119
on the
).
button to start draining
to continue
.