Table of Contents
Advertisement
the display shows the request to drain the
reservoir (the indicator light
13. Press again the
from the reservoir into the deep pan.
14. Wait for the end of the drain flow.
A beep sounds when finished. The appliance
automatically switches to the sanitization
procedure.
Sanitization
Sanitization with steam allows to
remove the last residues of descaling
from the hydraulic circuit.
The display will show the request to fill the
reservoir with water.
1. Open the door.
2. Place the deep pan on the third shelf from
the bottom. Push it against the rear wall of
the oven cavity.
3. Pull the loading drawer out of its housing.
4. Insert the funnel provided in the loading
drawer.
5. Using a bottle or a measuring jug, pour in
water until the tank is full (as shown by the
indicator light
6. Press the
button to start the function.
The appliance starts the 30-minute sanitization
procedure.
7. Wait for the function to be executed until the
end.
Take care: wait for the oven cavity to
cool down.
At the end of the function, the appliance
suggests the drain reservoir function.
8. Open the door.
9. Place the deep pan on the third shelf from
the bottom. Push it against the rear wall of
the oven cavity.
10. Press the
button to confirm.
The water starts to flow into the deep pan from
the drain pipe on the right side of the rear wall
of the oven cavity.
11. Wait for the end of the drain flow.
At the end the appliance makes a beep and the
display shows
90 - CLEANING AND MAINTENANCE
comes on).
button to drain the water
on the display).
.
12. Drain the water from the deep pan.
13. Wipe off any spillage of water in the
cooking compartment with a cloth or
sponge.
14. Close the door.
Manual descaling
When you wish to perform descaling in
advance, you can run the function manually:
1. Open the door.
2. Place the deep pan on the third shelf from
the bottom. Push it against the rear wall of
the oven cavity.
3. After entering the special functions menu,
press the
button until the
function is selected.
4. Press the
button to confirm.
5. Proceed with the descaling procedure as
described in the previous paragraphs.
Cleaning the reservoir and hydraulic
circuit
This function allows the reservoir and the
hydraulic circuit of the appliance to be cleaned.
Preliminary operations
1. Open the door.
2. After entering the special functions menu,
press the
button until the
function is selected.
3. Press the
button to confirm. The indicator
light
flashes.
Reservoir filling
1. Place one litre of clean water into a jug.
91477A653/B
Advertisement
Table of Contents
