Smeg Classica SO6104APN Manual page 57

5. Wait for the end of the drain flow.
6. Empty the water in the jug (or container).
7. Touch the CONFIRM
continue the function.
From now on, it will no longer be
possible to cancel the descaling
process.
Reservoir filling
1. Mix 100 g of citric acid with 650 ml of
water in a jug.
Do not use lactic acid or other
descaling agents.
2. Remove the loading wand from its holder.
3. Place the end of the tube at the bottom of
the jug (or container).
4. Touch the START
the reservoir with the descaling solution.
5. When finished, shake the loading wand to
remove any residue.
6. Place the loading wand back in its holder.
7. Remove the jug (or container).
Boiler descaling function
1. Close the door
2. Touch the START
function.
3. Descaling starts.
After completion of the descaling process the
request to drain the descaling solution will be
displayed.
Reservoir draining
1. Open the door
2. Place a jug or container on the open door.
3. Remove the loading wand from its holder.
4. Press the START
the descaling solution into the jug (or
container).
The descaling solution begins to flow into the
jug.
5. Wait for the end of the drain flow.
6. Empty the descaling solution from in the jug
(or container).
Take care: the descaling solution may
be still hot.
91477A081/A
button to
button to start filling
button to start the
button to start draining
Cleaning the reservoir and the water circuit
Once the descaling solution has been drained,
the appliance starts the cleaning procedure for
the reservoir and the hydraulic circuit.
Use cold tap water which is not too
hard, softened water or still mineral
water.
Do not use distilled water, tap water
with a high chloride content (> 40 mg/
l), or other liquids.
The display will show the request to fill the
reservoir with water.
1. Fill a jug or a container with approx. 2 litres
of clean water.
2. Open the appliance door.
3. Place the jug (or container) on the open
door.
The overflowing of water inside the
oven cavity is not intended as a
malfunction, rather it is part of the rinsing
procedure.
4. Remove the loading wand from its holder.
5. Place the end of the tube at the bottom of
the jug (or container).
6. Press the start
appliance reservoir with water.
7. When you have finished filling water into the
reservoir, touch the CONFIRM
to continue with the function.
The appliance starts the function using the
parameters set.
• When cleaning the reservoir and the
hydraulic circuit, leave the jug on the door
open with the loading wand inside. The
appliance cyclically discharges certain
quantities of water used for cleaning.
• During this process, the overflowing of water
inside the oven cavity is not intended as a
malfunction, rather it is part of the rinsing
procedure.
8. After completion of the cleaning process the
request to drain the water is shown on the
display.
9. Clean and dry any residual water inside the
oven cavity.
10. Open the door
11. Place a jug or container on the open door.
12. Remove the loading wand from its holder.
CLEANING AND MAINTENANCE - 129
button to start filling the
button