Table of Contents
Advertisement
Manual reservoir filling
Function for filling water (or other
liquids) into the reservoir.
1. Fill a jug supplied or a container with a
sufficient amount of water for the duration of
the functions that you wish to use.
2. Open the appliance door.
3. Place the jug (or container) on the open
door.
The jug (or container) with the water
must have a gross weight lower than 5
kg.
4. Touch the OTHER FUNCTIONS
button on the "main menu" (in the main area
).
5. Touch the sub-menu
the lower area
6. Touch the FILL RESERVOIR
7. Remove the loading wand from its holder.
• To remove the loading wand, press on the
front of the wand until the spring contracts,
then release.
• Touch the WAND button
display (positioned in the lower area
Pay attention to the distance to be
maintained so as not to be hit by the
wand projection.
120 - USE
button (located in
).
button.
or
on the
8. Place the end of the tube at the bottom of
the jug (or container).
9. Press the start
appliance reservoir with water.
10. When finished, shake the loading wand to
remove any water residue.
).
11. Place the loading wand back in its holder.
12. Remove the jug (or container).
13. Close the door.
When the door is closed, an automatic
system will automatically draw in any
residual water in the loading wand to
avoid drips. A bubbling noise may be
heard; this is completely normal.
button to start filling the
91477A081/A
Advertisement
Table of Contents
