Generac Power Systems PowerPact G0065201 Installation Manuallines page 11

Section 2: Unpacking and Inspection
General
NOTE: After unpacking, carefully inspect the contents for
damage. It is advised to unpack and inspect the unit
immediately upon delivery to detect any damage that
may have occurred in transit. Any claims for shipping
damage need to be filed as soon as possible with the
freight carrier. This is especially important if the generator
will not be installed for a period of time.
•
This standby generator set is ready for installation
and has a weather protective enclosure that is
intended for outdoor installation only.
•
This UL listed, 2-pole switch is rated at 32 amps,
rated at 250 volts maximum.
• If any loss or damage is noted at time of delivery,
have the person(s) making the delivery note all
damage on the freight bill or affix their signature
under the consignor's memo of loss or damage.
• If a loss or damage is noted after delivery, separate
the damaged materials and contact the carrier for
claim procedures.
• "Concealed damage" is understood to mean
damage to the contents of a package that is not
evident at the time of delivery, but is discovered
later.
Required Tools
• General SAE and Metric hand tools
– Wrenches
– Sockets
– Screwdrivers
• Standard electrician's hand tools
– Drill and bits for mounting and routing conduits
• Pliers
•
Needle Nose Pliers (for fuel conversion)
• 4mm and 6mm Allen wrenches
• 3/16 Allen wrench (test port on fuel regulator)
• Manometer (for fuel pressure checks)
• Meter capable of measuring AC/DC Voltage and
Frequency
Installation Guidelines for 50 Hz PowerPact™
Unpacking
1. Remove cardboard carton.
2. Remove the wood frame.
Figure 2-1. Crated Generator
3. There are four fasteners securing the top lid.
Remove the four Allen fasteners and lift the top lid
from the generator enclosure.
4. Once the lid is open, remove the front panel by
lifting it up and out. Also open the door covering the
customer connection area.
5. Perform a visual inspection for any hidden freight
damage.
Unpacking and Inspection
001128
7