Table of Contents
Advertisement
TOOLS: Performing procedures in this section may require the use of tools including:
Flat blade and philips head screwdrivers, standard and or metric socket set/wrenches, torque wrench, hex (Allen) keys and
side cutters.
10.1 Installing Amputee Bracket
For ths procedure, refer to FIGURE 1 on page 84.
1.
Refer to the following chart or FIGURE 1 to determine the mounting position of the amputee bracket:
SEAT-TO-FLOOR
ADULT
ADULT
HEMI
HEMI
* - "A" and "B" are stamped on the sides of the amputee bracket.
2.
Install the amputee bracket on the wheelchair frame to the position determined in STEP 1.
Make sure the axle spacer is pointing towards the outside of the wheelchair.
3.
Install the two hex screws and locknuts that secure the amputee bracket to the wheelchair.
4.
Install the rear wheels onto the wheelchair. Refer to Removing/Installing Rear Wheels on page 52.
Part No. 1110550
BRACKET
AXLE SPACER POSI-
TION (ON BRACKET)
*
A
DOWN
*
B
DOWN
*
UP
B
UP
*
A
SIDE OF
WHEELCHAIR
RIGHT
LEFT
RIGHT
LEFT
83
BRACKET MOUNTING POSITION
(ON WHEELCHAIR)
TOP
TOP
BOTTOM
BOTTOM
Invacare® Tracer® SX5 Wheelchair
10 OPTIONS
Advertisement
Table of Contents
