Table of Contents
Advertisement
TOOLS: Performing procedures in this section may require the use of tools including:
Flat blade and philips head screwdrivers, standard and or metric socket set/wrenches, torque wrench, hex (Allen) keys and
side cutters.
9.1
Replacing Heel Loop
For this procedure, refer to FIGURE 1 on page 64.
1.
Pull the cam lock lever up to unlocked position.
2.
Perform one of the following:
•
Footplates with Spring Buttons (Detail "A"):
i.
Push in the release buttons and remove the footplate assembly from the front rigging support.
•
Bolt-In-Place Footplates (Detail "B"):
i.
Using a screw driver to hold the threaded rivet in position, remove the button head screw from the threaded rivet.
ii.
Remove the threaded rivet and button head screw securing the footplate assembly to the front rigging support.
3.
Remove the mounting screw, spacer and locknut that secure the heel loop to the footplate.
4.
Remove existing heel loop from slide tube.
5.
Install new heel loop onto slide tube.
6.
Install the mounting screw, spacer and locknut to secure the heel loop to the footplate. Tighten until the spacer is secure.
7.
Insert the lower footrest assembly into the upper footrest assembly to desired height.
Part No. 1110550
63
9 SERVICE
Invacare® Tracer® SX5 Wheelchair
Advertisement
Table of Contents
