Table of Contents
Advertisement
7 ADJUSTMENT
7.6
Adjusting Quick-Release Axle
WARNING
NEVER use quick-release axles on the SX5 recliner wheelchairs.
1.
Remove rear wheel and quick-release axle from the wheelchair. Refer to Removing/Installing Rear Wheels - Quick Release Axle Only on page 40.
2.
Depress detent pin in the quick-release axle and slide axle through
the rear wheel hub.
3.
Release detent pin ensuring that the detent balls are fully released.
4.
Increase or decrease end play by adjusting the locknut on the end
of the quick-release axle.
WARNING
Make sure detent pin and detent balls of the
quick-release axles are fully released before
operating the wheelchair.
Keep detent balls clean.
5.
Reinstall rear wheel onto the wheelchair. Refer to
Removing/Installing Rear Wheels - Quick Release Axle Only on
page 40.
Invacare® Tracer® SX5 Wheelchair
Axle Bushing
Detent Balls
Axle Spacer
(Conventional Arms Only)
FIGURE 7
58
Quick-Release
Detent Pin
Rear Wheel Hub
Adjusting Quick-Release Axle
Part No. 1110550
Axle
Locknut
Advertisement
Table of Contents
