Table of Contents
Advertisement
9 SERVICE
9.3
Installing/Removing the Back Canes
Reverse this procedure to remove the back canes.
1.
Remove the hex screw and locknut from the bottom of one back
cane.
2.
Position threaded insert into the bottom of each back cane with nut
facing the outside of the wheelchair and aligned with the mounting
hole in the bottom of the back cane.
3.
Insert the back cane into the mounting hole in the wheelchair frame.
4.
Position the hex screw through the wheelchair frame, back cane,
and threaded insert.
The hex screw should be inserted from the inside
of the wheelchair frame.
5.
Torque the hex screw to 60-80 inch pounds.
6.
Install the locknut onto the hex screw. Secure the hex screw to prevent
it from backing out and torque the locknut to 60-80 inch pounds.
Invacare® Tracer® SX5 Wheelchair
Outside of
Wheelchair
Nut
Locknut
Wheelchair
Frame
FIGURE 3
66
Back Cane
Threaded Insert
Hex Screw
Inside of Wheelchair
Replacing the Flip-Back Armrest
Part No. 1110550
Advertisement
Table of Contents
