Table of Contents
Advertisement
7 ADJUSTMENT
Bolt-In-Place
This procedure applies to the swingaway front riggings and swingaway elevating legrest.
1.
Remove the swingaway front rigging. Refer to Installing/Removing Front Riggings on page 35.
Lay the front rigging assembly on a flat surface to simplify this procedure.
2.
Pull the cam lock lever up to the unlocked position.
3.
Using a screw driver to hold the threaded rivet in position, remove the button head screw from the threaded rivet.
4.
Remove the threaded rivet and button head screw securing the footplate assembly to the front rigging support.
5.
Adjust the footplate assembly height by aligning the desired adjustment holes in the upper front rigging support and lower footplate assembly.
6.
From the outside of the swingaway front rigging, insert the threaded rivet through both the front rigging support and the footplate assembly.
7.
From the inside of the swingaway front rigging, insert the button head screw through the appropriate adjustment hole and thread into the threaded rivet.
8.
Using a screwdriver to hold the threaded rivet in position, securely tighten the button head screw. Torque to 32 in-lbs.
9.
Rotate cam lock lever down to locked position.
10. Repeat STEPS 1-9 to adjust the remaining footrest.
Front Rigging Support
Swingaway
footrest shown
Inside of Swingaway Front Rigging
Invacare® Tracer® SX5 Wheelchair
Adjustment
Hole
Button Head Screw
Cam Lock Lever
FIGURE 4 Adjusting Footplate Height - Bolt-In-Place
Front Rigging Support
Button Head
Screw
Adjustment Hole
Threaded Rivet
Footplate Assembly
Outside of Swingaway Front Rigging
54
Threaded Rivet
Footplate
Assembly
Part No. 1110550
Advertisement
Table of Contents
