Figure 9: Ln2600 Router Screw Removal - Juniper LN2600 Hardware Manual

Rugged security router

Hide thumbs Also See for LN2600:

Table of Contents

Figure 9: LN2600 Router Screw Removal

1—

Router screws

Place the wall-mounting drill hole template on the wall (concrete or plywood wall as

required) and drill four holes on the exact pre-drill locations marked on the template.

Ensure that the drill hole template is leveled properly.

The wall-mounting drill hole template is a paper template that comes with the

wall-mounting unit. The template has exact mount hole locations marked.

NOTE:

Ensure that you have a minimum of 355 mm (14 in) space to the

left and that of 250 mm (10 in) to the right of the wall-mounting drill hole

template.

For installing the LN2600 router on a wall:

If you are using Tapcon

depth of 2.25 inch.

If you are using Hilty

inch.

For installing the LN2600 router on a plywood surface, drill the pilot screw holes of

1/8 inch.

Install the respective screws (or anchors as required) to the drill holes till you have

1/4 inch of the screw left.

Place the wall-mount unit on top of the screws (or anchors) through the key holes

present on the wall-mount unit, and tighten the screws to secure the wall-mount unit

in place..

Chapter 3: Installing the LN2600 Rugged Security Router

2—

Router nuts

concrete screws, drill the screw holes of 3/16 inch to a

anchors, drill the anchor holes of 1/4 inch to a depth of 1.5

Table of Contents