Snmp Trap Configuration - Planet Networking & Communication IGS-10020HPT User Manual

4.2.2.3 SNMP Trap Configuration

Configure SNMP trap on this page. The SNMP Trap Configuration screen in
The page includes the following fields:
Object
•
Trap Config
•
Trap Mode
•
Trap Version
•
Trap Community
•
Trap Destination
Address
• Trap Destination Port
Figure 4-2-2-3: SNMP Trap Configuration Page Screenshot
Description
Indicates which trap Configuration's name for configuring. The allowed string
length is 0 to 255, and the allowed content is ASCII characters from 33 to 126.
Indicates the SNMP trap mode operation. Possible modes are:
Enabled: Enable SNMP trap mode operation.

Disabled: Disable SNMP trap mode operation.

Indicates the SNMP trap supported version. Possible versions are:
 SNMP v1: Set SNMP trap supported version 1.
 SNMP v2c: Set SNMP trap supported version 2c.
 SNMP v3: Set SNMP trap supported version 3.
Indicates the community access string when send SNMP trap packet. The
allowed string length is 0 to 255, and the allowed content is the ASCII characters
from 33 to 126.
Indicates the SNMP trap destination address.
Indicates the SNMP trap destination port. SNMP Agent will send SNMP message
via this port, the port range is 1~65535.
User's Manual of IGS PoE series
Figure 4-2-2-3
91
appears.