Snmp Configuration; Introduction To Snmp - Planet Networking & Communication WGSW-50040 Configuration Manual

ip address <ip_address> <mask>
[secondary]
no ip address <ip_address> <mask>
[secondary]
ipv6 address <ipv6-address /
prefix-length> [eui-64]
no ipv6 address <ipv6-address /
prefix-length>
3. BOOTP configuration
Command
VLAN Port Mode
ip bootp-client enable
no ip bootp-client enable
4. DHCP configuration
Command
VLAN Port Mode
ip bootp-client enable
no ip bootp-client enable

4.4 SNMP Configuration

4.4.1 Introduction to SNMP

SNMP (Simple Network Management Protocol) is a standard network management protocol widely used in
computer network management. SNMP is an evolving protocol. SNMP v1 [RFC1157] is the first version of
SNMP which is adapted by vast numbers of manufacturers for its simplicity and easy implementation; SNMP
v2c is an enhanced version of SNMP v1, which supports layered network management; SNMP v3
strengthens the security by adding USM (User-based Security Mode) and VACM (View-based Access
Control Model).
SNMP protocol provides a simple way of exchange network management information between two points in
the network. SNMP employs a polling mechanism of message query, and transmits messages through UDP
(a connectionless transport layer protocol). Therefore it is well supported by the existing computer networks.
SNMP protocol employs a station-agent mode. There are two parts in this structure: NMS (Network
Configure the VLAN interface IP address;
ip address <ip_address> <mask> [secondary]"
command deletes VLAN interface IP address.
Configure IPv6 address, including aggregation global
unicast address, local site address and local link
address. The no form command deletes IPv6
address.
Explanation
Enable the switch to be a BootP client and obtain IP
address and gateway address through BootP
negotiation; the "no ip bootp-client enable"
command disables the BootP client function.
Explanation
Enable the switch to be a DHCP client and obtain IP
address and gateway address through DHCP
negotiation; the "no ip bootp-client enable"
command disables the DHCP client function.
4-6
the "no