Snmp Trap Configuration - Planet Networking & Communication WGSW-48040HP User Manual

4.3.3 SNMP Trap Configuration

Configure SNMP trap on this Page. The SNMP Trap Configuration screen in
The Page includes the following fields:
Object
 Trap Config
 Trap Mode
 Trap Version
 Trap Community
Figure 4-3-2: SNMP Trap Configuration Page Screenshot
Description
Indicates which trap Configuration's name for configuring. The allowed string
length is 0 to 255, and the allowed content is ASCII characters from 33 to 126.
Indicates the SNMP trap mode operation. Possible modes are:
 Enabled: Enable SNMP trap mode operation.
Disabled: Disable SNMP trap mode operation.

Indicates the SNMP trap supported version. Possible versions are:
 SNMP v1: Set SNMP trap supported version 1.
 SNMP v2c: Set SNMP trap supported version 2c.
 SNMP v3: Set SNMP trap supported version 3.
Indicates the community access string when send SNMP trap packet. The
allowed string length is 0 to 255, and the allowed content is the ASCII characters
from 33 to 126.
User's Manual of WGSW-48040HP
Figure 4-3-2
72
appears.